Finally a finished test print

Picture 66 of 102

With the prior setup was unable to get a test print to finish completely - was getting jams in the wade's at the idler - adding a heat sink to the aluminum mounting plate helped get a print to finish, but the real problem was a floating PTFE liner in the PEEK which I found out quite a bit later when trying to print at higher speeds...


2 thoughts on “Electronics Projects

  1. Hi there,

    Just wondering if you can give any idea of approximately how long it takes you to assemble this unit once you have all your materials to hand? GREAT post and I’m SO grateful – thank you!!

Leave a Reply to marco Cancel reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>